General Description; Specification Plate; Use; Place Of Use And Temperature - MIL'S SEC A Manual De Operación Y Mantenimiento

1.

GENERAL DESCRIPTION

In order to guarantee personal protection and avoid any material damage, it is essential
to follow the instructions given in this manual and all other documents supplied with the
dryer.

1.1. Specification plate

In order to simplify any future requests for spare parts or further information about your DRYER, we advise
you to copy onto this page the specifications written on the identification plate of the DRYER, as soon as
you receive your equipment.
Type
Model
Sérial number
Date of fabrication
Power supply
Maximum pressure
Fluid group II

1.2. Use

The equipment must only be used for its intended purpose: with its cylinders fitted with 'dessicant' (=
drying system), the dryer/degassing unit is designed to dry and degas air, without aggressive elements.

1.3. Place of use and temperature

Ambient temperature between +1°C and +35°C.
In case of long-term storage, the dryer's inlets and outlets should be plugged, in order to avoid moisture
penetration. The storage area must be dry and temperate.
In case of use at temperatures lower than +1°C, a system of heating is necessary upstream in order to
eliminate the risk of ice formation.

1.4. Expiration time

There must not be more than one year between the reception date and the installation date of the
'dessicant' cylinder.
After one storage year, molecular sieves are out of date.

1.5. Handling

Lift the treatment system using the specially lifting points provided for this purpose.
Ensure that the lifting equipment is of sufficient capacity!

1.6. Dimensions AD5XXX

See ANNEX
518718-12
SEC A / 1A / 2A / 7OX / 7HC –AD 5xxx
Dryer
16 bar

1.7. Characteristics of AD5XXX

AD5035 AD5065 AD5130
Inlet flow rate
[Coefficient P = 1 -> *] and [Coefficient T = 35°C = 1 -> #]
for network
35 65
10 bar in m³.h -1
Dryer tubes HC
T35HCx2 T65HCx2 T65HCx4
(for SEC7HC)
Dryer tubes OX
(for SECA / SEC1A T35OXx2 T65OXx2 T65OXx4
/ SEC2A / SEC7OX)
* Coefficient [P] according to the operating pressure
Bar 7 8
Coefficient P 0.84 0.89
# Coefficient [T] according to inlet temperature °C
Inlet temperature °C +25
Coefficient T for –45°C dew point in
1.25
reduced air
Permissible maximum pressure of use: 16 bar.
AD5195 AD5260 AD5325 AD5455
129 195 260 325
T65HCx6 T65HCx8 T65HCx10 T65HCx14
T65OXx6 T65OXx8 T65OXx10 T65OXx14
10 12 14
1 1.1 1.18
+30 +35 +40 +45
1.15 1 0.85 0.62
Equipment fit to 2014/68/UE pressure directive.
9
455
16
1.26
+50
0.5