PICO PicoScope 6000E Serie Guia Del Usuario página 11

User's Guide
When cleaning the product, use a soft cloth and a solution of mild soap or detergent in water. To prevent electric
shock, do not allow liquids to enter the oscilloscope casing, as this will compromise the electronics or insulation
inside.
Do not block the air vents at the back or front of the instrument as overheating will damage the oscilloscope.
Do not insert any objects through the air vents as internal interference will cause damage to the oscilloscope.
2.7 OEM and long-term applications
If using this PicoScope 6000E Series oscilloscope for OEM applications or other continuous use, please contact
Pico Technology's Technical Support team
cooling and ventilation.
2.8 Conformance
General statement of conformity
The enclosed instrument has been calibrated in accordance with the manufacturer's
verification procedure using standards that are traceable to UK national standards. The test
location's quality management system complies with, and its calibration process is controlled
under, ISO 9001:2015. The calibration processes are designed to certify that the instrument
was within its published specification at the time of calibration. The measurements were
made in a monitored environment.
A full calibration certificate including test data and traceable to national standards is available
on request. Please refer to
FCC notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference which the user will be required to correct at their own expense.
CE notice
This PicoScope 6000E Series oscilloscope has been designed and tested in accordance with the following European
Union directives: 2014/30/EU (EMC), 2014/35/EU (LVD), 2012/19/EU (WEEE) and 2011/65/EU, incorporating
Commission Delegated Directive 2015/863/EU (RoHS), and left the factory in a safe condition.
For more information, please refer to your product's EU declaration of conformity, available for free download from
picotech.com/downloads.
DO338-5
WARNING
CAUTION
(support@picotech.com
picotech.com/products
Copyright © 2020–2021 Pico Technology Ltd. All rights reserved.
or +44 (0) 1480 479 164) for advice on power,
for pricing.
PicoScope 6000E Series oscilloscopes
Continued overleaf
7