Solid State Logic Matrix Guia De Instalacion página 11

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
Tested To Comply
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
with FCC Standards
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
FOR HOME OR OFFICE USE
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
The symbol shown here is on the product or on its packaging, which indicates that this product must not be disposed of with other waste. Instead,
I I n n s s t t r r u u c c t t i i o o n n s s f f o o r r D D i i s s p p o o s s a a l l o o f f W W E E E E E E b b y y U U s s e e r r s s i i n n t t h h e e E E u u r r o o p p e e a a n n U U n n i i o o n n
it is the userʼs responsibility to dispose of their waste equipment by handing it over to a designated collection point for recycling of waste electrical
and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural
resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can
drop off your waste equipment for recycling, please contact your local city office, your household waste disposal service or where you purchased
the product.
This apparatus fully conforms with the current protection requirements of the European community council directives on EMC and LVD.
S S t t a a n n d d a a r r d d s s C C o o n n f f o o r r m m a a n n c c e e
Warranty claims will only be accepted if the purchased product has been used for its intended purpose. Any purchased product used for an unintended purpose
L L i i m m i i t t e e d d W W a a r r r r a a n n t t y y
will not be eligible for warranty protection. For all warranty inquiries or claims please address your claim to the dealer that you purchased the product from – or to
Solid State Logic if the purchase was directly from Solid State Logic – within a period of two months from the date on which you detected its lack of conformity
with the terms of the warranty. Please include your original proof of purchase when initiating the claim.
• Within the EU:
Pursuant to the Solid State Logic Terms and Conditions under European consumer law the purchaser has full statutory warranty rights
for two years from the date of delivery of the product. The warranty is valid only in those Member States of the European Union (EU) who
have adopted the applicable EU law into their national legislation. The applicable national legislation governing the sale of consumer
goods is not affected by this warranty.
• Outside of the EU:
Outside of the European Union a 12 month warranty from date of purchase is applicable.
In the event of a fault arising after the warranty period has expired the unit should be returned to Solid State Logic either directly or via your local dealer. You will
O O u u t t o o f f W W a a r r r r a a n n t t y y R R e e p p a a i i r r s s
be charged for the time spent on the repair (at Solid State Logic's current repair rate) plus the cost of parts and shipping. Note that no units can be accepted for
repair without prior arrangement (see below).
• No unit will be accepted for repair by Solid State Logic unless accompanied by a valid RMA (Return Material Authorisation) number, obtainable from Solid State
A A l l l l R R e e t t u u r r n n s s
Logic prior to shipping.
• All units should be shipped to Solid State Logic in suitable rigid packaging – Solid State Logic cannot be held responsible for any damage caused by shipping
units in other packaging. In such cases Solid State Logic will return the unit in a suitable box, which you will be charged for.
• Do not include the power cable, manual or any other items – Solid State Logic can not guarantee to return them to you.
E E N N
D D E E
F F R R
E E S S
I I T T
J J P P
7