Bathtub Installation; Freestanding; Models: Bbe 01, Bbe - WET Style BBE 01 Guia De Instalacion

Bathtub installation - FREESTANDING
Models: BBE 01, BBE02, BC 0101, BC 0401, BC 0801, BC 0802, BC 0803, BC 1001, BC 1101,
BC 1201, BC 1401, BCL 01, BCLB 01, BCR 01, BOV 01-62, BOV 01-66, BOV 02, BOV 03,
BST 01, BTP 01, BWA 01, BLB 01, BLB 02 and BMD 01.
Decide exactly where you wish to install the bathtub. Clean, level and prepare the floor for
1
installation.
Place the unit in the exact installed position on the floor and trace the outline of the bath with
2
a pencil or any erasable marking.
Using a blanket, cardboard, or other clean protective surface, turn the unit on its side so that
3
the unit is properly supported during drain installation.
2
Install the basic plumbing components: water inlet and floor drain. These tub models require a
4
vertical plumbing connection from the floor. A horizontal connection is only possible if the side
wall of the bathtub is pierced.
Clean the drain hole area in preparation of setting the drain. The area should be dry and free
of any debris. Apply a bead of clear silicone or plumber's putty around the Drain Body and
pass it through the drain hole. Apply plumber's putty to the Washer and slide it over the
bottom of the Drain Body.
4
P. 4
3
WETSTYLE Plug & Bathe overflow and
drain connection system includes:
Soft-touch pop-up drain, for built-in
overflow. Fits both 1-3/4" tubular brass.
PUTTY
or
Washer.
SILICONE
1-1/2" ABS Direct vertical drain waste
fitting (copper/brass option also
available).
ABS
PIPE
1-1/2" ABS 90º Elbow drain waste fitting
GLUE
(copper/brass option also available).
Montréal - Canada | 1-888-536-9001 | www.wetstyle.com | November 2019
Installation guide
TM