Twin-Star International 23IW1254 Manual De Instrucciones Adjunto página 5

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. Locate the Center Front Panel (D), Right Front
Panel (C), Left Front Panel (B) and Center Front
Bar (H) set out face down on a scratch-free surface.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Right Front Panel (C) and Left Front Panel
(B) snug to the Center Front Panel (D) and Center
Front Bar (H). Make sure the Wood Dowels are
seated in the pre-drilled holes. Insert Bolts (AA) and
Washers (BB) into the holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA
Bolt
BB
Washer
CC
Wood Dowel
2. Locate Hearth/Base (A) and set out finished side up
on the floor.
Insert one Wood Dowel (CC) into each of the
pre- drilled holes.
Attach the completed Front panel assembly from
step 1 to the Hearth/Base (A). Make sure the dowels
are seated into the pre-drilled holes in the
Hearth/Base. Using Bolts (AA) and Washers (BB)
attach panels through pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
Fig. 1
CC
C
x 2
x 2
x 8
Fig. 2
CC
x 2
x 2
x 4
4
CC
D
B
H
BB
AA
AA
BB
A
AA