Front Panel - HP Latex Cutter Serie Información De Introducción

Front panel

The front panel is located on the front right of the cutter. It gives you complete control of your cutter: from the front
panel, you can view information about the cutter, change cutting settings, perform calibrations and tests, and so on.
The front panel also displays alerts (warning and error messages) when necessary.
Icons
Front-panel error codes
Under certain circumstances, a numeric error code appears on the front panel. Follow the advice in the
Recommendation column to resolve the error. If the recommendation does not seem to solve the problem, call your
service representative.
If an error code appears on the front panel that is not included in this list, turn off the cutter and then turn it back on.
If the problem persists, call your service representative.
4
Menu
Move to the left / Go to previous item
Move to the right / Go to next item
Cancel the current process
HP Barcode reading
Move up / Increase value
Move down / Decrease value
Start / Pause
ENWW