Modulator Frequency Setting - Alpine CRM-1652RF Manual De Operación

3
1.2.4
1
POWER
(Remote Display Unit/Unité
d'affichage de télécommande/
Unidad de visualizador de
control remoto)
2
POWER
(Remote Display Unit/Unité
d'affichage de télécommande/
Unidad de visualizador de
control remoto)
3
DN UP
(Remote Display Unit/Unité
d'affichage de télécommande/
Unidad de visualizador de
control remoto)
4
POWER
(Remote Display Unit/Unité
d'affichage de télécommande/
Unidad de visualizador de
control remoto)
12
Basic Operation
CD Operation
1.2.4

Modulator Frequency Setting

3
FREQ.
Press the POWER button to turn on the unit.
PWR
(Remote Control Unit/
Unité de télécommande/
Unidad de control
remoto)
FREQ.
Press and hold the POWER button (for at least
2 seconds).
PWR
(Remote Control Unit/
Unité de télécommande/
Unidad de control
remoto)
Use the UP and DN buttons to select the
FREQ MHz
89.9
desired frequency. Make the selection while the
Frequency mode is displayed. The Frequency
is varied by 200 kHz (0.2 MHz) steps from 87.7
to 89.9 MHz.
DN UP
M.S.CD
(Remote Control Unit/
Unité de télécommande/
Unidad de control
remoto)
Press the POWER button.
FREQ.
Notes:
PWR
• Select a frequency that is not used by a
strong, local FM station. This will prevent
interference while listening to CD.
• To listen to an FM broadcast, turn down the
(Remote Control Unit/
Unité de télécommande/ volume of the radio then turn power off to
Unidad de control
the CRM-1652RF. Tune the radio to your
remoto)
desired station and adjust the volume to
your preference.
English
English