MTX Audio Blueprint Serie El Manual Del Propietario página 3

Tabla de contenido

Publicidad

MTX WARRANTY INFORMATION
All MTX In-Wall Speakers purchased in the United States from an authorized MTX
dealer are guaranteed against defects in material and workmanship for a period ten years from
the date purchased by the end user, and limited to the original retail purchaser of the product.
Product found to be defective during that period will be repaired or replaced by MTX at no
charge. This warranty is void if it is determined that unauthorized parties have attempted repairs
or alterations of any nature. Warranty does not extend to cosmetics or finish. Before presuming
a defect is present in the product, be certain that all related equipment and wiring is functioning
properly. MTX disclaims any liability for other incurred damages resulting from product defects.
Any expenses incurred in the removal and reinstallation of product is not covered by this war-
ranty. MTX's total liability will not exceed the purchase price of the product. If a defect is present,
your authorized MTX dealer may be able to effect repairs.
Proof of purchase is required when requesting service, so please retain your sales
receipt and take a moment to register your product on line at www.mtx.com.
STEP 1
Using a stud finder (available at low cost at most hardware stores) or other accurate method, locate
center point between two studs and mark. Using template provided, trace hole pattern on surface of
wall. Placing a bubble level on either the horizontal or vertical guidelines of template will assist you in
leveling the hole pattern.
STEP 2
Using a sabre saw, keyhole saw or very sharp utility knife, cut hole in wall, following traced pattern.
STEP 3
Run loudspeaker wires to sound source location. There are several methods you can use to accomplish
wiring, depending on the construction characteristics of the room or house. You can add a professional
touch to your installation by using a speaker terminal plate at the source location. Leave sufficient amount
of wire at speaker location (8 to 10 inches) to complete connection.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Blueprint 502wBlueprint 602w

Tabla de contenido