70mai Dash Cam Lite MiDrive D08 Manual De Usuario página 6

lower than -10℃ .
16. Please note that the housing's temperature rises when the device
is running.
17. Use this product within the scope of the law.
Specifications
Model: Midrive D08
Image sensor: SONY IMX307
Resolution: 1920×1080
Camera: FOV 130°
Wireless connection: Wi-Fi IEEE 802.11 b/g/n/ 2.4GHz
G-sensor: Acceleration sensor
Expandable memory: MicroSD card with capacity of 16-64GB and
read/write speed of Class10 and above
Supported OS: Android4.4/iOS9.0 and above
Power supply: Car cigarette lighter
Battery type: Li-polymer battery
Battery capacity: 500mAh
Input: 5V 1.5A
Operating temperature: -10℃ ~ 60℃
Dimensions: 82 × 58.2 × 40.5mm
8
FCC
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
9