Product Safety Information; Product Specifications - Ingersoll Rand EP50 Serie Especificaciones Del Producto

Product Safety Information

Intended Use:
This Air Engraving Pen is designed for writing or engraving on metals and other hard materials.
For additional information refer to Product Safety Information Manual Form 16576704.
Manuals can be downloaded from ingersollrandproducts.com.

Product Specifications

Weight
Model
oz. (kg)
EP50 5 (0.14)
EP50-EU 5 (0.14)
*K = Vibration measurement uncertainty
Adjustments
Changing the Stylus
Your new EP50-EU Air Engraving Pen comes equipped with a standard stylus. However, a fine
and coarse stylus are available at extra cost. To change the stylus proceed as follows:
1. Carefully grasp the Housing in copper-covered or leather-covered vise jaws, inlet downward.
2. Using a wrench on the flats of the Nosepiece, unscrew and remove the Nosepiece. (Turn
counterclockwise to remove).
3. Remove the Stylus Spring and the Stylus.
4. Install the Stylus Spring onto the new Stylus and insert the Stylus into the Housing.
5. Screw the Nosepiece into the Housing and tighten securely. (Turn clockwise to install).
Grinding the Stylus
1. Insert the Stylus in the stylus grinding collet; then insert the stylus grinding collet into a spin
index (Whirley Gig).
2. Position the Stylus at an angle against the grinding wheel surface.
Note: The grinding angle should be the same as the angle already on the Stylus.
3. Turn the spin index toward the grinding wheel as you are sharpening the Stylus. Grind until
the Stylus is sharp.
4. Remove the Stylus from the stylus grinding collet.
5. Position the Stylus in a lathe and spin.
6. Using a diamond dressing stick, put a radius on the stylus tip.
Important: The stylus tip must have a radius to prevent chipping. Normal radius is 0.008".
16584039_ed2
Length
Blows
per min.
in (mm)
5 5/8 (137) 18750
5 5/8 (137) 18750
Sound Level dB (A)
(ANSI S5 - 1971)
Power
Pressure
(ISO3744)
75.8 --
75.8 --
EN
Vibration
(ISO28927) m/s²
Level *K
4.6 0.9
4.6 0.9
EN-1