DBI SALA Delta Vest Manual Del Usuario página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 13 - Delta Vest™ Harness Buckle Connections
Chest Strap: Pass male buckle
through female buckle and pull free
end of webbing to tighten.
Parachute Buckle: Pass webbing
under buckle and over roller and
down between roller and frame.
Pull web end to tighten. Three
inches of web must extend past
buckle.
B. VEST STYLE
HARNESS: If your
harness incorporates
loops for a removable
waist belt, the belt
should be installed
through the four loops
in the harness as shown
in Figure 14. The hip
pad, if used, is secured
to the belt by passing
the belt through the hip
pad loops. Don the vest
style full body harness
by following these steps
(see Figures 15 and
16):
Step 1.
Locate back D-ring held in position by the D-ring pad;
lift up harness and hold by this D-ring. Ensure the straps
are not twisted.
Step 2.
Grasp the shoulder straps and slip harness onto one
arm. D-ring will be located on your back side. Ensure
Tongue Buckle: Pass webbing
through buckle and insert tongue
through grommet.
Pass Buckle: Pass male buckle
through female buckle and pull free
end of webbing to tighten.
Figure 14 - Removable Waist Belt
& Hip Pad
19

Publicidad

Tabla de contenido
loading

Productos relacionados para DBI SALA Delta Vest

Tabla de contenido