Low Flame Adjustment; Burner Ignition And Autoreignition; Burner Ignition - FCI Home Appliances COGB 33060/BL Manual De Instalación

Low Flame Adjustment

DANGER
Lighting gas burners with a match is
dangerous. You should match light the
cooktop burners only In an emergency.
Light a match and hold the flame near the burner
you want to light. Wooden matches work best.
Push in and turn the control knob slowly.
Be sure you are turning the correct knob for the
burner you are lighting.
NOTE:
If the burner does not light within five seconds, turn
the knob off and wait one minute before trying again.
WARNING
If you attempt to measure the inner cone of the
flame, please use caution.
Burns could result.
This appliance is shipped from the factory with low
and medium flame settings adjusted.
If further adjustment is necessary, proceed as follows:
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
3. Insert a slender, thin-blade screwdriver into the
recess at centre of valve stem and engage blade
with slot in adjusting screw.
4. Turn center stem adjusting screw to set flame
size.
• clockwise to reduce
• counterclockwise to increase
5. Replace control knob when adjustment is
completed.
Proper adjustment will produce a stable, steady blue
flame of minimum size. The final adjustment should
be checked by turning knob from high to low several
times without extinguishing the flame.
This adjustment, at low setting, will automatically
provide the proper flame size at medium setting.
After Conversion Steps have been completed, check
the appearance of each burner's flame at the Hi and
Lo settings, if the flames appear too large or too small
review each step to make sure it was completed
correctly.

Burner Ignition and Autoreignition

This appliance is equipped for electronic auto-
reignition by means of a spark igniter located near
each burner. The burners are designed to light at any
valve rotation that admits sufficient gas flow to support
Cooktop & Installation Manual
a flame and to automatically relight following a loss of
flame due to a draft or other adverse condition. This
feature is provided as a convenience and is not
intended as a safety feature.

Burner Ignition

Cooktop Spark Ignition. When you turn the cooktop
knob to LITE, the spark igniter makes a series of
electric sparks (ticking sounds) which light the burner.
During a power failure, the burners will not light
automatically. In an emergency, a cooktop burner may
be lit with a match by following the steps below.
The Burner Flames
Turn each burner on. Flames should be blue in color
with no trace of yellow. The burner flames should not
flutter or blow away from the burner The inner cone of
the flame should be between 1/2" and 3/4" long.
COUNTERCLOCKWISE
TO INCREASE
FLAME SIZE
021
Figure 21. Low flame adjustment
COOKTOP BURNER
003
Figure 22. Burner flames
18
Model COGB ENGLISH
CLOCKWISE
TO REDUCE
FLAME SIZE
VALVE STEM
-1/2" to 3/4"