Muskoka MQHS11BWL Instrucciones Del Usuario página 6

6. Press the
"
hi low up
/
is .
high
7.
to calibrate the thermostat, hold down the "
calibration screen. the LeD display will flash. the default setting on the display is 00. the ˚F or ˚C light will illuminate.
Press the "
hi low up
/
should match your wall or free-standing thermometer within 6 degrees. Once the desired temperature is set, press the
" " button again to save your settings. to reset the thermostat to the factory settings, hold the "
temperature
button for 5 seconds. this will reset the temperature settings back to 00.
Note: the heater has a 2 to 6 degree tolerance. Please calibrate the thermostat 6 degrees higher in case the heater does
not activate after setting the thermostat.
8. to turn off the heater, press the "
unplug the heater until the fan shuts off. If the heater is left on using the timer function, there is a 5 second sound alert to
let you know that time is expiring. If no action is taken, the heater will shut off.
efficiency Tips
• Do not place the heater in an area with high airflow.
• Direct the flow of hot air towards the centre of the room. Do not aim the heater towards walls or doors. For larger areas,
position the heater in a central location.
• The heater is designed for a optimum temperature efficiency range of 68˚F - 74˚F (20˚C - 24˚C)
• Existing HVAC heating system vents should be covered or closed. This allows the heater to work within an isolated area.
• We do not recommend the use of the heater in areas exposed to non-insulated concrete, brick or metal walls. Concrete
floors should be covered to insulate the heat within the room.
• If the heater filters become dirty or dusty, they must be cleaned for the heater to operate at it's maximum efficiency.
6
" button to switch between
˚C
"
up
between High and
˚F
˚F ˚C
/
temperature
" button or the ˚ ˚ "
C F down
/
˚C
Hold the "
to switch to thermostat.
˚F
Press "
to increase/decrease
˚F ˚C
/
˚C
Press the "
to set the thermostat.
˚F
Hold the "
to reset the settings.
˚F ˚C
/
" button. Do not turn off the master power switch on the rear of the heater or
power
(1500W) and
high heat low heat
Press the
hi low
/
" button to switch
Low heat setting
" button for 5 seconds to switch the display to the thermostat
" button to adjust the temperature setting. the displayed temperature
" button
temp
" or "
"
up down
temperature by 1˚.
" button
temp
" button
temp
(750W) settings. the default setting
˚C
˚F
˚F ˚C
/
temperature
˚C
˚F
˚F ˚C
/
˚C
˚F
˚F ˚C
/
"