Speaker Terminals - Teac LS-W300 Manual Del Usuario

A

Speaker Terminals

CAUTION
To avoid damaging the speakers with a sudden high-level
signal, turn off the amplifier before connecting the speakers.
The black speaker terminals are _ (negative).
Generally, the + side of the speaker cable is marked to make it
distinguishable from the _ side of the cable. Connect this
marked side to the + terminal and the unmarked side to the
black _ terminal.
Prepare the speaker cables for connection by stripping off
approximately 10 mm or less of the outer insulation. (Removing
too much insulation may lead to a short circuit if the bared
wired should come in contact with each other.) Twist the
strands of the stripped wires tightly together:
CAUTION
The metal portions of the two separate wires should not touch
or an electrical short can occur. Shorted wires can create a fire
hazard or induce a failure in your equipment.
How to Connect
1. Turn the terminal cap counterclockwise to loosen it. The
speaker terminal caps cannot be fully removed from the
base.
2. Insert the wire into the terminal fully and turn the terminal
cap clockwise to securely connect it:
Make sure none of the wire insulation is under the terminal,
only the bare, stripped wire.
3. Make sure it is fastened firmly by pulling the cable lightly.
B Subwoofer
Connect to the Subwoofer output jack of the amplifier with
the supplied RCA cable.
C
AC Power Cord
After all other connections have been completed, connect
the plug to the AC wall socket.
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord.
5