Installation In The Laboratory; Environmental Operating Conditions - Caframo BDC250 Manual Del Usuario

Installation
( includes motor only)
BDC250MU1
Stand Assembly
Remove lock nut. Insert the threaded end of the stand rod into the stand base.
Turn rod clockwise to tighten. Secure with lock nut.
Stirrer Installation
Slide the clamp opening over the top of the stand rod. Lower to desired height.
Turn clamp knob to securely tighten the stirrer onto the stand rod. Connect sup-
plied power cord to stirrer. Connect power cord to a grounded electrical outlet.
Impeller Assembly
Add impeller blade(s) to impeller shaft. Tighten screw to secure.
Impeller Installation
Insert impeller shaft into collet opening until it stops. Tighten set screw.

Environmental Operating Conditions

The BDC250 stirrer must operate in the following conditions:
Indoors
1. Altitudes up to 2000 m (6500 ft.).
2. Temperatures from 5 C to 40 C (41 F to 104 F).
o o o o
3. Maximum relative humidity 80% for temperatures up to 31 C (88 F) decreasing
o o
linearly to 50% relative humidity at (104 F).
o
4. Pollution degree 2 in accordance with IEC 664.
5