Disposing Of Obsolete Electronic Equipment; Warranty Certificate - fluidra ConnectBox Manual

Rear part
There are a number of buttons and inputs of different types that allow ConnectBox perform all its functions:
•
Reset button. If pressed for more than 10 seconds, the unit is reset to factory settings, erases any settings the user has created
and returns to the version of software with which it was manufactured. Note! This section only describes some of the settings that
are reset. A reset must be done by a professional and must not be performed by an end user. A reset can cause the total or partial
loss of configuration data depending on the installation.
•
SW1 button. If pressed for more than 10 seconds, ConnectBox goes into access point mode if the previous status was Wi-Fi client
mode (see the footnote on the previous page).
•
Female Ethernet connector. The use of category 5 cables or higher is recommended.
• RS-485 connector. Connect a twisted-pair communication cable between terminals A +, B- and GND, and connect it following the
standard for systems based on RS-485 communications.
Assistance and after-sales service
In case of queries or issues:
1. Contact the service engineer or dealer who sold/installed the unit.
2. If the problem cannot be solved, contact the Fluidra Comercial After-Sales Helpline in your country

Disposing of obsolete electronic equipment

1 All electrical and electronic products should be disposed of at collection points designated by the government or local
authorities, rather than at municipal waste collection sites.
2 The proper disposal of your old appliances will help prevent potential risks to the environment and public health.
3 For more information about the disposal of your old appliances, please contact your refuse collection service or the store
where you purchased the product.

Warranty certificate

Fluidra Comercial, extends a two-year warranty period on the product "ConnectBox" (hereinafter, the "Product") in the country of sale after
its delivery to the consumer by the vendor, subject to the terms and conditions described in this warranty.
This warranty covers the following parts of the Product:
- ConnectBox
- Power pack
According to these provisions, the seller shall cover any defects in materials or workmanship to which the Product may be subject during the
warranty period.
Conditions for the warranty claims:
(a) The manufacturer's instructions included in the documentation accompanying the Product must have been strictly followed.
(b) The invoice or delivery note, if dated later than the invoice, must be submitted.
(c) Any defects must be reported within two months of becoming aware of them.
This warranty covers the repair or replacement of the Product or defective parts or, if applicable, a discount price or termination of the
contract if the Product has neither been repaired nor replaced.
To exercise the warranty, the consumer must contact the authorised service vendor.
Exclusions:
Under no circumstance shall the Product be deemed defective and, therefore, the Fluidra Comercial warranty shall not apply in the country
of sale of the Product, if defects in materials or workmanship of this Product are due to:
(a) Unauthorised modifications of the product.
(b) Misuse, abuse or negligence in the use of the Product.
(c) Incorrect Product installation or start-up, or installation carried out by an unauthorised service engineer.
(d) Damage to the Product due to a force majeure event or an act of God.
(e) The lack of preventive maintenance stipulated in the instruction manual.
Any other warranty rights that are not expressly mentioned herein are likewise excluded.