TROUBLESHOOTING
NOTE: Before performing any maintenance or cleaning work, always pull out the mains plug and wait until the cutter has come to a
standstill.
Fault
Motor does not run
Motor power drops
Grass catcher is not filled
sufficiently
SPARE PARTS LIST PLUG REPLACEMENT
This Grass Trimmer is supplied with a ¬fitted plug. If you should need to ¬t a new plug, please follow these instructions. Safely
dispose of the old plug Connect plug as shown in the diagram on the left Connect the Blue-Neutral and Brown-Live. No connection
is to be made to the earth terminal of the plug. Only ¬t the same speci¬cation fuse as ¬tted to the original plug. Recommended
fuse: 13 Amp (BS1362). Note If a moulded plug is ¬tted and has to be removed, take great care in disposing of the plug and severed
cable. The severed plug must be destroyed to prevent its re-use, or connection to any electrical supply.
1. Check mains connection cable and circuit - breaker (fuse).
2. Start on short grass or on an area which has already been mown.
3. Clean discharge channel/housing - the mowing blade must rotate freely.
4. Correct the cutting height.
1. Correct the cutting height.
2. Clean discharge channel/housing.
3. Have mowing blade replaced - customer service centre
1. Correct the cutting height.
2. Allow the lawn to dry.
3. Have mowing blade replaced - customer service centre.
4. Clean the grille on the grass catcher.
5. Clean the discharge channel/housing.
Remedial action