Mitsubishi Electric PAC-WHS01WF-E Manual De Instalación página 3

(Improper handling may have serious consequences, including serious injury or death.)
■This device complies with Industry Canada's
licence-exempt RSSs. Operation is subject to
the following two conditions:
(1)This device may not cause interference;and
(2)This device must accept any interference,
including interference that may cause
undesired operation of the device.
■This equipment complies with radio
frequency exposure limits set forth by the
FCC and Industry Canada for an uncontrolled
environment. This equipment should be
installed and operated with a minimum
distance of 20 cm, 7.8 inch between the
device and the user or bystanders. This
device must not be co-located or operating
in conjunction with any other antenna or
transmitter.
(Improper handling may have consequences, including injury or damage to house.)
■To prevent damage from static electricity,
touch a nearby metal body to discharge static
electricity from yourself before touching the
Wi-Fi interface.
Static electricity from the human body may
damage the Wi-Fi interface unit.
■Do not install the Wi-Fi interface in a place
with much steam, such as bathroom.
Avoid places where water is splashed or where
condensation forms on walls. Installing in such
places can cause electric shock or breakdown.
■Do not install the Wi-Fi interface in places
with direct sunlight or where the ambient
temperature is 40ºC, 104ºF or more or is
0ºC, 32ºF or less.
Direct sunlight and high or low temperature
environments may cause the Wi-Fi interface to
deform or breakdown.
■ Please ensure that the access point supports
both WPS connection and the WPA2-AES
encryption setting before commencement of the
installation of the PAC-WHS01WF-E.
■ The End user should read and accept the Terms
and conditions of the Wi-Fi service before
commencement of the installation of PAC-
WHS01WF-E.
■ To complete connection of the PAC-
WHS01WF-E to the Wi-Fi service physical
access to the access point may be required.
■Visit http://kumocloud.com for additional
information about controlling the PAC-
WHS01WF-E from your web browser or smart
phone.
Warning
■Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
■Do not connect the Wi-Fi interface to earth
inside the air conditioner.
Caution
■Do not use in special environments.
Use in places with much oil (including machine
oil), steam, or sulfuric gas may lead to severe
decrease in functionality and damage to parts.
■Turn off power supply of connected
equipment when performing construction or
wiring work.
Failure to turn off the power supply to the
connected equipment may lead to malfunction or
breakdown of the Wi-Fi interface or connected
equipment.
■Dismantling the indoor unit.
Please refer to the indoor units "service manual"
for detailed instructions for accessing the control
interface connector CN105 on the indoor unit
control PCB.
Note
■ The PAC-WHS01WF-E should not be installed
and connected to any Mitsubishi Electric system
which is to provide cooling or heating to critical
applications.
■ Details of the air conditioner and PAC-
WHS01WF-E can be recorded on page 7 'Setting
Information'.
■ The PAC-WHS01WF-E will not commence
transmission of any operational data from the
system until the End user registers and accepts
the terms and conditions of the Wi-Fi service.
3