Important; Mount The Cabinet To Gearwall Panels Or Geartrack Channel - Whirlpool Gladiator Instrucciones De Instalación

Mount the Cabinet to GearWall

IMPORTANT:

®
Be sure the GearWall panels or GearTrack
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
®
If GearTrack channels will be used to support the Gladiator
Large GearBox cabinet, you must use three channels installed
18" (45.72 cm) apart.
18" (46 cm)
NOTE: The three nuts on the center and bottom mounting brackets
must be loose enough to allow the brackets to move in the slots.
1. Close the cabinet doors.
2. Determine cabinet mounting location on GearWall
®
GearTrack channel.
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
3. Using two or more people, engage the top bracket into the slots
by lifting up, pushing toward the wall and lowering the bracket
rims into the slots as shown.
4
® Panels or GearTrack
4. Make sure the top bracket is fully engaged in the slots as shown.
®
channels are
®
5. Open the cabinet doors.
®
panels or
6. From inside the cabinet, grasp the bolts in the center bracket and
7. Push the cabinet toward the wall and lower the center mounting
8. Make sure the center bracket is fully engaged in the slot as
9. Repeat for the bottom bracket.
10. Using a ¹⁄₂" wrench, fully tighten the nuts attaching the center and
®
A
B
A. Bracket rim
B. Slot
adjust the bracket until it aligns with the slot in the GearWall
panels or GearTrack ® channels.
bracket into the slots.
shown.
bottom brackets.
Channel
C
C. Mounting bracket
fully engaged
®