Safety Features; Motor Overload; Ground-Fault Circuit-Interrupter Protection; Extension Cords - DeVillbiss WATER DRIVER SERIES WD1600E Manual De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.0

SAFETY FEATURES

The pressure washer is equipped with a stop device which will sense when the trigger on the gun
is released. It will open the power circuit to the motor and cause the pressure washer to stop.
The pressure washer is also equipped with a main power ON/OFF switch
located on the unit. It should always be moved to the off position when the
pressure washer is not being used to prevent possible injury or damage.

MOTOR OVERLOAD

The electric motor in this pressure washer is equipped with an overload protection device which
will automatically shut off the motor in the event the motor draws excessive current or overheats.
The device will automatically reset itself and resume normal operation after a short period of time.

GROUND-FAULT CIRCUIT-INTERRUPTER PROTECTION

This pressure washer is provided with a ground-fault circuit-
interrupter (GFCI) built into the plug of the power supply cord.
This device provides additional protection from the risk of
electric shock. Should replacement of the plug or cord
become necessary, use only identical replacement parts that
include GFCI protection.

EXTENSION CORDS

extension cords are not recommended
unless they are plugged into a ground-
fault circuit-interrupter found in circuit boxes or protected
receptacles.
Use only 3-wire extension cords that have 3-prong grounding-type plugs and 3-pole cord
connectors that accept the plug from the product.
Use only extension cords that are intended for outdoor use. These extension cords are identified
by a marking "Acceptable for use with outdoor appliances; store indoors while not in use".
Use only extension cords having an electrical rating higher than the rating of the product.
Do not use damaged extension cords. Examine extension cord before using and replace if
damaged.
Do not abuse extension cord and do not yank on any cord to disconnect. Keep cord away from
heat and sharp edges. Always disconnect the extension cord from the receptacle before
disconnecting the product from the extension cord.
When using an extension cord, observe the specification below:
Cable Length
Up to 50 ft.
50 to 100 ft.
To reduce the risk of electrocution, keep all connections dry and off the
ground. Do not touch plug with wet hands.
D28921
Wire Gauge
14 AWG
12 AWG
8- ENG

Publicidad

Tabla de contenido
loading

Tabla de contenido