Yakima EXO WarriorWheels Manual De Instrucciones página 3

4
INSTALL THE SNAPAROUNDS™, BOLTS, AND HANDLE.
NOTE: The handle must be installed
on the same side as the front
wheels (the wheels that can swivel).
Install the snaparounds on the
bar in the locations shown.
5
INSTALL THE KNOBS.
Install the knobs and fully tighten them.
REMOVAL
A. Remove the knobs, bolts, and SnapArounds™
that secure the handle. Remove the handle.
B. Remove the knobs that secure the wheels
and then remove the wheels.
CAUTION! Never operate the vehicle with
the EXO WarriorWheels™ installed on your
EXO System. You must remove the wheels
and handle before operating the vehicle!
Instruction #1036043A - page 3 of 6
1.5 Nm
With the handle resting
on the ground, align the
handle and thread the bolts
through the snaparound
and handle as shown.
6
DETACH YOUR BASKET.
Refer to your basket
instructions to remove
the EXO GearWarrior™
from your EXO System.
X Nm
IMPORTANT!
Be sure to read all
the warnings and
warranty information
contained in the
insert accompanying
these instructions!