Changing The Filter; Replacement Parts & Optional Accessories - Lumiscope LUMINEB II Instrucciones De Operación

1 . Use one part white vinegar to three parts distilled water . Make
sure the mixed solution is enough to submerge the nebulizer and
mouthpiece .
2 . Wash the nebulizer, mouthpiece and/or mask in warm water with a
mild detergent, then rinse the detergent solution out with hot tap
water .
3 . Submerge the cleaned components in the water and vinegar solution
for thirty minutes .

CHANGING THE FILTER

1 . Use only Lumiscope nebulizer filters .
2 . Do not substitute cotton or any other materials . Do not wash, clean
or re-use a filter .
3 . Never operate your LUMINEB II without a filter .
4 . Change the filter every 30 days or when it turns gray .
To change the filter:
1 . Remove the filter cover on the top of the compressor unit .
(see page 5)
2 . Replace the old filter with a new one .
3 . Replace the filter cover .
REPLACEMENT PARTS
Replacement parts are available - please contact our Customer Service
Department at 770-368-4700 .
OPTIONAL ACCESSORIES
Adult Mask (item 5704)
5710-INS-LAB-RevB14 9