Setting Up The Handset For Use - Verizon V500AM Manual Del Usuario

Verizon V500 / USA EN / A31008-M1931-R301-1-6019 / starting.fm / 30.4.08
First Steps
Reception strength:
The display shows if the handset is linked
to the base station:
Ä is on: handset is linked to the base
u
station.
Ä flashes: no reception; handset is out
u
of range or not registered.
Connecting the base station
¤
First connect the power adapter and
then the phone jack as shown below.
1
1 110-V power adapter
2 Back of the base station
3 Phone jack with phone cords
Please note:
u
The power adapter must always be
connected, as the phone will not oper-
ate without an electrical supply.
u
Your answer machine is set to give a
standard announcement.
8
3
2

Setting up the handset for use

Inserting the batteries
Caution:
Use only rechargeable UL-approved AAA bat-
teries. Never use a conventional (non-
rechargeable) battery or other battery types as
this could result in significant health risks and
personal injury. For example, the batteries
could explode. The phone could also malfunc-
tion or be damaged as a result of using batter-
ies that are not of the recommended type.
Note:
If attached, remove the belt clip before open-
ing the battery cover.
¤
Open the battery cover.
¤
Insert the batteries according to the
correct polarity (see diagram).
The polarity is indicated in/on the battery
compartment.
¤
Close the cover, and press the top so
that it clicks into place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.