Working With Module „Standard; Working With Module „Nearfield; Working With Other Modules - TDK relyon plasma piezobrush PZ3 Manual De Instruccion

7.5 Working with module „Standard"
This module is used for various applications on
non-electrically conductive substrates / materials
such as plastics, ceramics, glass, natural fibers,
leather, textiles etc. The range of the permissible
working distance is approx. 2 to 10 mm.
Electrically conductive substrates such as
metals or conductive polymers cannot be reliably
treated with this nozzle.
When treating electrically conductive substrates
/ materials, arcing can occur if the distance is too
small. In this case the unit will stop plasma
generation after approx. 0.5 seconds.
7.6 Working with module „Nearfield"
The module "Nearfield" was especially
designed for the treatment of electrically
conductive substrates / materials such as
metals or conductive polymers. Even partially
conductive materials such as carbon fiber
reinforced plastics (CFRP) should be treated
with this module.
The device can only generate a surface
activation if an electrically conductive substrate
is in front of the device within the range of the
permissible working distance. This is approx.
0.5 to 2.0 mm. If the distance is greater, plasma generation may not be possible under
certain circumstances, depending on the material and geometry of your substrate.
If too great a distance is selected, the unit
automatically stops plasma generation after
5 seconds.
Caution - hot surface!
The module can become hot during operation. Do not touch the module immediately after
operation. Do not touch the substrate with the module during operation.
7.7

Working with other modules

It is planned to develop further modules for this device. Please refer to the corresponding
operating instructions enclosed with these modules.
BA-PZ3_ML / F0354401 21