Blaupunkt BPV 660 Manual Del Usario página 5

Adjusting the Sound Characteristics
1.
Press the AUDIO to select the desired adjustment mode
as follows;
BASS 0
TREBLE 0
LOUD OFF (LOUDNESS)
X-BASS 0
L0 R0 (BALANCE)
R0 F0 (FADER)
LE Lo (LEVEL METER)
2.
Rotate the VOL dial to adjust the selected item.
Use the following tables as a guide for adjusting the set-
tings in each mode.
Adjust within 5 seconds after selecting the item. After 5
seconds, the unit returns to previous indication.
Adjustment Range
BASS BASS –5
TREBLE TREBLE –5
LOUDNESS LOUD OFF
X-BASS X-BASS 0
BALANCE L9 R0(Full left)
FADER R9 F0(Full rear)
LEVEL METER OFF Lo (Normal)
Tip
Settings for BASS, TREBLE, LOUDNESS and XBASS can
be made to each of the following modes independently:
FM, AM, CD, CD Changer and AUX.
E-4
Enhancing the bass sound
For extended bass centered @ 72Hz, Blaupunkt's X-BASS
function can be set for either each band and CD mode.
You can select :
• X-BASS 1 : Enhanced BASS level (low).
• X-BASS 2 : Enhanced BASS level (Middle).
• X-BASS 3 : Enhanced BASS level (High).
• X-BASS 4 : Enhanced BASS level (Very high).
• X-BASS 0 : No BASS enhanced.
AUDIO
Press the
dow. Each time you rotate the VOL dial, the current mode
appears on the display window and the mode change as fol-
lows:
Note
Reduce XBASS level if your combination of speakers and add-
on amplifiers sound distorted at the preferred sound level.
BASS 5
Level Meter Sensitivity selection
TREBLE 5
The sensitivity of the level meter display can be switched.
LOUD ON
You can select :
• OFF (No indication)
X-BASS 4
• Low
: Normal (Low) sensitivity.
L0 R9(Full right)
• High
: High sensitivity.
R0 F9(Full front)
1.
Press the
Hi (High)
window.
2.
Rotate the VOL dial to select the desired meter sensitiv-
ity.
to display the " X-BASS " on the display win-
X-BASS 0 (No display)
X-BASS 1
X-BASS 2
X-BASS 3
X-BASS 4
AUDIO
to display the " LE Lo " on the display
:
OFF
:
Lo
: Hi
Switching the Source (Selecting auxiliary
input)
You can connect auxiliary equipment (Portable cassette
player, etc) to this radio via optional AUX-IN cable. (See page
9)
CD
Each time the is pressed, the operation source will
change over as shown below;
RADIO CD CD changer or AUX
Press the BAND to return to tuner mode.
Note
If the CD button is pressed when no CD has been loaded
into the unit, The CD mode will skip to the CD changer mode
or AUX mode.
Also, if the CD changer is not connected, the system will move
across to the AUX mode regardless of whether auxiliary equip-
ment is connected or not (" AU " will be displayed.)
It is not possible to switch to the AUX mode when the CD
changer is connected.