Insert Battery - Cooper Scantronic Security 720r Manual Del Usuario

INSTALLATION

Insert Battery

Remove the mounting plate (if fitted) and connect a 9V (PP3) battery.
The activity LED flashes and the detector sounder gives a loud tone for one second. This
tone indicates that the detector is working.
Note: If the sounder clicks once a second then a fault has occurred or the battery is totally
exhausted. Replace the battery and check that the sounder gives a one second tone.
Learning
Put the receiver into learn mode (consult the relevant section in the receiver's Installation
and Programming Guide.)
Radio Learning:
IR Learning:
While you are holding the test button down, after 3 seconds the detector gives five rapid
clicks as it transmits its identity.
Press and hold the test button for seven seconds.
Hold the detector so that the IR learn LED points at the learn sensor
on the receiver. Make sure the learn LED on the detector is no more
than 25mm from the learn sensor on the receiver. Press and hold the
test button for three seconds.
8