How To Operate Your Ceiling Fan; Important - Upright LP8577 Manual Del Usuario

How to Assemble Your Light Kit or Cap (continued)
6. Assemble the LED assembly to the light kit using
the two key slots. Replace the removed screw from
Step 3 and secure all three screws. (Figure 6)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
7. Secure the glass to light kit
clockwise direction. Do not over-tighten. (Figure 7)
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
by twisting in a

How to Operate Your Ceiling Fan

WARNING
WARNING
Light Kit
LED Assembly
For illustrative purposes only-not
intended to cover all types of controls
13
Figure 6
Light Kit
Glass
Figure 7
Figure 1
MAIN FUSE BOX
Figure 2