To Vacuum With A 5/8" Garden Hose (Not Included)
1. Extend the telescopic pole to its fullest length.
3. Attach the vacuum bag to the vacuum head, tighten the
drawing string and tie a simple shoelace knot.
5. Hand tighten a 5/8" garden hose to the vacuum head.
6. Secure the hose into the hose clip.
5/8" hose
Hose Clip
8. Turn on the water supply, it will create a venturi action at
the vacuum head to collect debris into the vacuum bag.
10. When done or the bag is full:
A) Slowly move the vacuum head to the side wall of the pool, turn the vacuum head up-side-down, shut off the water and remove the vacuum head from the pool.
B) Remove the vacuum bag and discard all the debris, flip the bag in-side-out and rinse with running water.
11. Repeat the vacuuming process until the pool is thoroughly cleaned.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
4
Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
2. Attach the vacuum head to the open end of the telescopic pole.
4. Twist off the water hose cap.
7. Place the vacuum under water.
9. Slowly push the vacuum head across the pool floor to remove the debris.