Installing The Tweeter; Surface Mounting - Orion HCCA52 Manual Del Propietário

step 7: Pull the wire through the speaker opening and connect to the speaker . be sure to
observe proper mid/woofer polarity during this process .

InsTallInG THe TWeeTeR

suRfaCe MounTInG

step 1: Determine the tweeter mounting location, then route the wires from the crossover to
the tweeter location .
step 2: Place the provided template or tweeter cup against the panel and mark the two holes
at the rear of the housing .
step 3: Drill the smaller holes using a 1/8" drill bit . These are the mounting screw holes .
WARNING: Check for clearance of window mechanisms and electrical wires befoRe you drill .
step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet and route the
speaker wire from the crossover through the grommet .
step 5: after removing the surface mount tweeter assembly trim ring, route the tweeter wires
through the larger hole in the housing and connect to the speaker wires from the
crossover . (see figure 4 .)
step 6: Insert the excess speaker wire into the hole and position the housing so the housing
will not pinch the wires after final mounting .
step 7: attach the housing using the supplied screws of the correct length for a solid mount .
step 8: Insert the tweeter into the housing and attach the surface mount trim ring .
4
step 8: Mount the speaker- Place the speaker and the grille in the
installation hole . align the mounting screw holes and drive in the four
mounting screws .
SURFACE MOUNTING SCREWS
MOUNT
TRIM RING
Figure 2
Figura 2
Abbildung 2
TWEETER
SURFACE MOUNT HOUSING
TWEETER
WIRE PANEL
© 2012 MD Audio Engineering—all rights reserved
WIRING HARNESS