Pre-Installation - AquaPRO 54021-0 Manual Del Usuario

17. The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The protector will
reset itself once the motor cools down and an acceptable temperature has been reached. The pump may start
unexpectedly if it is plugged in.
18. Ensure the electrical power source is adequate for the requirements of the pump.
19. Before using the pump, check the hose for holes or excess wear, which could cause leaks, and ensure the
hose is not kinked or making sharp angles. A straight hose allows the pump to move the greatest amount of
water quickly, and also check that all hose connections are tight to minimize leaks.
20. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long
time when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt,
or debris may cause the pump to fail. Please carefully read the manual and follow the instructions regarding
common pump problems and remedies.

PRE-INSTALLATION

APPLICATION
 This pump is designed for portable applications. It can drain or remove water from the following: flooded areas,
pool covers, clogged sinks, waterbeds, water basins, boats, stock tanks, etc.
 It can also be used to fill tanks or water beds.
This pump has not been tested or approved for use in swimming pools or in salt-water marine areas.

This pump should not be used as a replacement for a sump pump.

SPECIFICATIONS
Power supply
Liquid temp. range
Discharge connection
Discharge hose needed
Power cord
INSTALLATION
1. Priming water
Add water (approximately 1-2 Tbsp.) into the inlet to wet the impeller of

the pump (A).
115V, 60 HZ.
32 to 77° F (0- 25° C)
3/4 in. garden hose thread connection
5/8 in. or larger discharge garden hose
SJTW, 18AWG/3C, 6 ft.
3