Rear Panel - Laney LA35C Manual Del Usaurio

Ocultar thumbs Ver también para LA35C:
Tabla de contenido

Publicidad

To eliminate "body resonance" feedback, switch the filter in with the push switch and adjust the control until the body resonation
reduces, you should find a sweet spot on the control where it disappears. Turning further out of the sweet spot will bring the
resonation back up again. This setting will be the optimum for that particular guitar but may need to be altered if you plug in
another guitar.
9
REVERB: When selected, applies reverb to Channel 2 only.
10
CHORUS CONTROLS: Use the push switch to turn on the chorus, then with the rotary controls, the rate & depth of the
chorus sweep can be determined. The LED flashes to indicate the rate.
REVERB: Controls the level of the springline reverb applied to both channels when selected individually
11
12
AUX IN: Fancy playing along to a backing track? Connect your CD/MP3 player here. Use the volume control on your CD/MP3
player to set the volume level of the signal. The amplifier controls the instrument volume level.
D.I. OUT: This socket provides a balanced output for direct injection of the amplifier signal into a mixing desk or power amplifier.
13
14
HEADPHONES: Socket for connecting a pair of quality headphones, the internal loudspeaker is automatically turned off.
POWER LED:
The led, w
15
16
MAIN POWER SWITCH:
17
POWER INLET SOCKET:
18
POWER FUSE:
This is the main safety fuse for the unit. The fuse protects the AC power to the amplifier. USE ONLY THE
CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL. If a fuse blows or fails and a replacement of the same
size and rating is installed and it in turn blows, the amplifier has
suffered a malfunction internally and needs immediate service from a
qualified technician. DO NOT TRY USING A FUSE OF HIGHER
RATING. Using a fuse that is too large in current rating may cause
serious, irreparable damage to the amplifier and presents a serious fire
hazard. The mains fuse ratings are detailed in the specs section on
page 7 of this manual.
19
REAR PANEL: Displays the model number, power requirements and
serial number of the unit.
hen 'on' Indicates that power is connected to the unit and it is ready to go.
Main power switch for the unit.
Connect to your power source. Make sure the specified voltage is correct for your country!
16
17
18
N15039
19

Publicidad

Tabla de contenido
loading

Tabla de contenido