Notes; Description; Technical Data; Commissioning - Cooper Hand Tools Weller WSB 80 Instrucciones Para El Manejo

1. Notes

The operating instructions for the supply unit used are also applicable in addition to these
operating instructions. The warning notes contained in the operating instructions for the
supply unit are to be read carefully prior to commissioning.
Repairs are only to be performed by authorised specialist personnel.
Only use those WELLER supply units that are suitable for connecting to the solder bath.
Do not store inflammable objects near the solder bath.
Above 500°C there are lead emissions measurable.
The small soldering bath remains hot for some time after switch off.

2. Description

The small soldering bath WSB 80 / WSB 150 was developed for use in industrial manufac-
turing. The soldering bath is suitable for connection to all supply units with an 80 W / 150W
connection. The solder bath temperature can be controlled continuously from 50ºC - 450ºC
/ 550 °C via the supply unit to which it is connected. The power supply (24 V safety extra
low voltage) is fed over a temperature resistant silicone cable.

Technical Data

WSB 80
Dimensions (mm): 5,9" x 4,72" x 2,56"
(L x W x H)
Soldering Bath (mm): H = 25; ø = 20
Supply Voltage: 24V
Power Rating: 80W
GB
Warm Up Time:
Temperature Range:

3. Commissioning

Ensure that there are no flammable or temperature sensitive objects near the soldering
bath.
Insert the soldering bath plug in the socket on the supply unit and lock by turning clockwi-
se. Switch on the supply unit. Set the required temperature on the supply unit (50ºC -
450ºC). Soldering can be started after the necessary warm up time.
Important: Risk of burns due to liquid solder and solder splashes. Wear appropriate
protective clothing to protect yourself from burns. Protect your eyes. Wear safety
glasses.

4. Equipotential Bonding

The soldering bath is linked to the supply unit over an equipotential bonding wire. Various
methods of realising equipotential bonding are possible. The setting up of equipotential
bonding is described in the operating instructions for the supply unit used.

5. Items Supplied

WSB 150
5,9" x 4,72" x 2,56" Small Solder Bath
(L x W x H) Operating Instructions
2,3" x 1,2" x 0,75"
(L x W x H)
24V
150W
Approx. 7 min. Approx. 11 min.
(50ºC - 350ºC) (50°C - 350°C)
50ºC - 450ºC 50°C - 550°C
7