Culligan WSH-C125 Manual Del Usuario página 2

INSTALLATION INSTRUCTIONS
for Wall Mount Showerhead, Model WSH-C125:
Installs on any standard " threaded shower arm
1 /
2
Functions only with shower filter cartridge in place; see insert procedure below
1. Remove existing showerhead from
shower arm by turning counterclockwise.
2. Clean any debris that may be present
on the threaded pipe.
3. Wrap included Teflon tape tightly
around shower pipe threads.
4. Place Culligan showerhead on shower
®
arm and tighten by hand, turning clockwise.
5. If additional tightening is necessary,
use a soft cloth on the nut to protect
the finish and then tighten with a wrench.
6. Check for leaks and tighten as needed.
CARTRIDGE INSERTION PROCEDURE
for Filter Cartridge, Model WHR-140:
1. Hold the body of the showerhead
firmly in one hand. With other hand,
turn the ribbed ring behind the face
counterclockwise to unscrew.
2. Grasp white filter cartridge and pull
cartridge up and to the side to remove.
3. REMOVE STICKER FROM BOTH SIDES OF
CARTRIDGE BEFORE INSTALLING. Place new
filter cartridge into position by pushing cartridge
down into cavity until seated
4. Align threads until faceplate clicks
into cavity, then turn entire faceplate
clockwise until secure
INSTALLATION INSTRUCTIONS
for Hand Held Showerhead, Model HSH-C135:
Installs on any standard " threaded shower arm
1
/
2
Functions only with shower filter cartridge in place; see insert procedure below
1. Remove existing showerhead from
shower arm by turning counterclockwise.
2. Clean any debris that may be present
on the threaded pipe.
3. Wrap included Teflon tape tightly
around shower pipe threads.
4. Place mounting bracket on shower arm
and tighten by hand turning clockwise.
5. If additional tightening is necessary,
use a soft cloth on the nut to protect
the finish and then tighten with a wrench.
6. Insert one black rubber washer (included) into
the smaller threaded end of the shower hose
and attach hose to the mounting bracket.
7. Insert remaining black rubber washer (included)
into the larger threaded end of the shower hose
and attach to the threaded end of the
showerhead handle.
8. Position showerhead in mounting bracket,
test system for leaks and tighten fittings
as needed.
CARTRIDGE INSERTION PROCEDURE
for Filter Cartridge, Model WHR-140:
1. Hold the handle of the showerhead
firmly in one hand. With other hand,
turn the ribbed ring behind the face
counterclockwise to unscrew.
2. Grasp white filter cartridge and pull
cartridge up and to the side to remove.
3. REMOVE STICKER FROM BOTH SIDES OF
CARTRIDGE BEFORE INSTALLING. Place new
filter cartridge into position by pushing cartridge
down into cavity until seated.
4. Align threads until faceplate clicks
into cavity, then turn entire faceplate
clockwise until secure.