Receiver Instructions; Learn A Remote; Configuration Of Channel 1 & 2 - Perel Tools EM01 Manual Del Usario

Each transmitter generates a code that must be " known" by a receiver in order to operate. Proceed to
the next step to store one or more transmitters in the receiver memory.
To learn a remote :
1. Connect the power supply to the receiver unit (see page 9)
2. Hold 'setup' button, ' SELECT'-led turns on after a few seconds.
3. Press any remote control transmitter button.
4. ' CONFIRM'-led lights when the code has been grabbed.
5. Release 'setup' button.
If neccesary repeat steps 2 to 5 to learn the codes for other transmitters.
31 transmitters can be stored. If memory is full, ' SELECT' and ' CONFIRM' will flash simultaneously when
'setup' button is pressed (see also next page to erase the memory).
The relay outputs can be set in different modes, from a simple on/of contact to a short or long timer.
Configuration of channel 1 'CH1' and channel 2 'CH2' :
1. Connect the power supply to the receiver unit (see page 9)
2. Push 'setup'-button repeatedly to select CH1 (left) or CH2 (right) output relay
3. Confirm with a long push ('CONFIRM' flashes 3 times). The selected relay will
remain ON
4. Push 'setup' -button a number of times, depending on the desired mode (see table).
At each press, 'SELECT' will flash a number of times, indicating the current mode
5. Confirm with a long push ('CONFIRM' flashes 3 times). The selected channel will
turn off and the unit is ready for use.
If necessary, repeat steps 2 to 5 for the remaining channel.
The unit returns to normal operation when left idle for 10s.
( Factory defaults: CH1: 1h timer, CH2: 0.5s pulse)
7.
flashes Mode
1 ON/OFF
2 0.5s pulse
3 5s timer
4 30s timer
5 1min timer
6 5min timer
7 15min timer
8 30min timer
9 1h timer