Electrical Safety - Atlantic TidalWave SH1450 Manual De Operación

Introduction
Thank you for selecting the TidalWave SH1450, SH2050, SH3600, SH5000, or SH6500
series pumps. Before using this pump please take a moment to review this manual.
To avoid an accident do not use the pump in any way other than as described in this
manual. Please note the manufacturer cannot be responsible for accidents arising because
the product was not used as prescribed. After reading this manual keep it as a reference
in case questions arise during use.
Flow
Chart:
(GPH)
Best Efficiency Point
Prior to Operation and Installation
• Check for any damage to pump and power cable that may have occurred during
the shipment.
• Check the model number to make sure it is the product that was ordered and verify
the voltage and frequency are correct.
Caution
• DO NOT operate this product under any condition other than those for which it is
specified. Failure to observe this precaution can lead to electrical shock, electrical
leakage, fire, water leakage or other problems.
• The pump is a 100/120 volt 60 Hz pump, please only use with a power supply voltage
within 100-120 volt 60 Hz.
• Never place your hand or any object in or near the inlet opening while this equipment is
operating. If pump inlet is clogged, always turn off the power supply and wait until the
motor is completely stopped before attempting to remove any clogged material.
• Please make sure that the power plug and the AC outlet receptacle is protected and away
from water or pump discharge hose to prevent accidental electric shock or short circuit.
• Always operate the pump completely submerged in water.
• Avoid dry operation, which will not only lower performance but can cause the
pump to overheat/malfunction, leading to electrical leakage, shock or premature failure.
• CAUTION: THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND
CIRCUIT INTERRUPTER.
• CAUTION: THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.
• WARNING:RISK OF ELECTRIC SHOCK - THIS PUMP IS SUPPLIED WITH A GROUNDING
CONDUCTOR AND GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK
OF ELECTRIC SHOCK, BE CERTAIN THAT IT IS CONNECTED ONLY TO A PROPERLY
GROUNDED RECEPTACLE.

Electrical Safety

• Electrical wiring should be installed by a qualified electrician in accordance with
all applicable safety regulations. Incorrect wiring can lead to a pump malfunction,
electrical shock or fire.
2
Recommended Operating Range Do Not Operate Range