5.4 Instructions on AC Usage
NOTE Acquaint yourself with the parameters
on the Control Panel to ensure correct usage
within the rated output of the generator set.
CAUTION The generator set can work at
its rated output only under constant
temperature, pressure and humidity. The
variation of temperature, pressure and
humidity may influence the output of the
generator.
The temperature range in which the unit
can be started is 15C
-40C
0
condition is:
· Surrounding temperature: 25C
· Surrounding Pressure: 100kPa
· Relevant Humidity: 30%
· Height above Sea Level: 1000m
5.4.1 Start the generator.
5.4.2 Connect the devices.
5.4.3 The generator can supply 110/220V AC,
(depending on your model) set the voltage
selector (if there is such a selector) to the
position suitable to equipment.
. The standard
0
0
Owner´s manual
If the generator is not equipped with a
voltage selector, there will be sockets of
110V and 220V respectively (according to the
acquired model), please plug the load wire in
the relevant sockets suitable for the loads.
5.4.4 Turn on the AC breaker.
5.5 Instruction on DC Usage
Pay special attention to the connection of
positive and negative poles in DC application.
CAUTION The DC output should not be
used as power supply for battery charging.
6. STOPPING THE ENGINE
6.1 For Emergency:
Set the ignition switch to OFF position directly
to stop the generator.
6.2 Under Normal Condition
6.2.1 Turn off the AC breaker and unplug all the
loads.
6.2.2 Run the unit for several minutes without
load to cool down the generator set.
6.2.3 Set the ignition switch to OFF position.
(Fig. 11)
6.2.4 Set the fuel switch to OFF position. (Fig.
12)
English
27