TEFAL EXPRESS POWER ZONE ANTI-CALC AUTOCLEAN Manual De Instrucciones página 15

1800121673 GV74XX 7lgues_110x154 17/03/11 15:17 Page13
PROBLEMS
Water streaks appear on the linen.
White streaks come through the holes in
the soleplate.
Brown streaks come through the holes in
the soleplate and stain the linen.
The soleplate is dirty or brown and may
stain the linen.
There is no steam or there is little steam. The water tank is empty (red warning light
Steam comes out around the collector.
The "water tank empty" red warning light
is flashing.
Steam or water escapes under the
appliance.
The "anti-calc" warning light is
flashing.
The soleplate is scratched or
damaged.
Environment protection first!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
If you have any problems or queries please call our Customer Relations team first for expert help and advice:
0845 602 1454 - UK
CAUSES
Your ironing board cover is soaked with
water as it is not suited to the power of a
steam generator.
Your generator tank is ejecting scale as it
has not been descaled regularly.
You are ironing at too high a
temperature.
You are using chemical descaling agents
or additives in the water for ironing.
Fabric fibres have accumulated in the
holes of the soleplate and are burning.
Your linen is not rinsed sufficiently or you
have ironed a new garment before
washing it.
You are using starch.
flashing).
The steam output control dial is set at
minimum.
The soleplate temperature is set to the
maximum.
The collector is not tightened correctly.
The collector seal is damaged.
The appliance is faulty.
The water tank is empty.
The rinse plug seal is damaged.
You have not pressed the "OK" button.
You have placed your iron flat on a
metallic rest-plate.
You have cleaned your soleplate with
an abrasive or metal pad or ironed
over a metal zip or clasp.
(01) 677 4003 - Ireland
SOLUTIONS
Check that your ironing board is suitable.
We recommend using a mesh type ironing
board to allow excess steam to escape and
to avoid steam venting sideways.
Rinse the collector (see § descaling your
steam generator).
See our recommendations regarding
temperature control setting.
Never add this type of product in the
water tank or in the boiler (see the page
for what water may be used). Contact an
Approved Service Centre.
Clean the soleplate with a non-metallic
sponge.
Ensure linen is rinsed thoroughly to remove
any soap deposits or chemicals on new
garments which may be sucked up by the iron.
Always spray starch on the reverse side of
the fabric to be ironed.
Fill the water tank.
Increase the steam output (control dial
on the control panel).
The steam generator operates normally
but the steam is very hot and dry, and
hard to see.
Tighten the collector.
Contact an Approved Service Centre.
Do not use the steam generator and
contact an Approved Service Centre.
Press the "OK" button on the control
panel until the warning light goes out.
Do not use the steam generator and
contact an Approved Service Centre.
Press the "OK" button on the control
panel until the warning light goes out.
Always place your iron on its base or
on the iron rest plate.
Refer to the section "clean the soleplate".
Avoid ironing over metal zips or clasps.
or consult our website - www.tefal.co.uk
FR
EN
IT
ES
PT
EL
TR
13