Installation; Antenna Setting; Antenna Setting For Satellite - Qviart undro Manual Del Usario

2.Installation

When powering on your product for the first time after purchase, you should get
the wiring connection first.
Tip: The default password is 0000. If you have forgotten your password, please
contact your local product distributor.

2.1Antenna Setting

Menu->Installation->Antenna Setting
1 Satellite: Press the OK button to display the satellite list, then use the Up/
Down button to highlight the satellite you want use to search, at last press the OK
button to choose the the satellite. (You can use the F1 button to choose more
satellite at the same time, then use the SAT button to do the Multi-Sat search )
2 Transponder: Press the Left/Right button to change the TP or press OK
button to display transponder list. (You can use the F1 button to choose more
transponder at the same time, then use the SAT button to do the
Multi-Transponder search)
3 LNB Frequency: Press the Left/Right button to change the LNB frequency.
4 LNB Power: Press the Left/Right button to select the required LNB power.
5 DiSEqC 1.0: Press the Left/Right button to select the required DiSEqC1.0
input.
6 DiSEqC 1.1: Press the Left/Right button to select the required DiSEqC1.1
input.
7 22kHz: Press the Left/Right button to select ON, OFF or Auto.
8 Network Search: You can implement network search if you set YES.
9 FAT Only: Only allows free TV programme if you set YES.

2.1.1 Antenna Setting for Satellite

Press the Left/Right button or OK button you can see the pre-stored Satellite list.
You can select, Add, Move, Delete, Rename Satellites in this menu.
9