Installing This Board - Sony LKRI-005 Manual De Instrucciones

Signal
b)
2048 × 1080
a) b)
2048 × 1080
a : Available
— : Unavailable when this board is used to connect with a PC
a) To use both the 1920 × 1080 (60 Hz frame rate) and 2048 × 1080 (60 Hz frame rate) signals, it is
recommended to select ROM3. ROM3 is the factory setting (all ON).
b)
The signals above are based upon Sony unique specifications. For details, please consult your Sony
dealer.
c)
Even if this board is connected with a computer incompatible with DDC (Display Data Channel), this
board can receive the above signals regardless of the signals being the EDID ROM compatible/
incompatible.
• This board is only compatible with progressive signals.
• If the projector into which this board is installed is incompatible with
• Select any one ROM for EDID ROM even if every memory types are
2
EDID ROM used
ROM1
ROM2
ROM3
ROM4

Installing this Board

Before you install this board, set the DIP switches (S101, S102).
For installing this board, refer to the "Installation Manual for Dealers"
of the projector.
Frame
rate (Hz)
48
60
Notes
signals, the signals cannot be input.
available (i.e. 1024 × 768 (VESA) signals with 60 Hz frame rate etc.).
Set the DIP switches (S101, S102) depending on the desired
resolution and frame rate.
For both the Switch 1 and Switch 2 of S101, the same setting is
required.
S101
Switch 1
ON
OFF
ON
OFF
Note
Dots EDID ROM used
clock
ROM1 ROM2 ROM3 ROM4
(MHz)
148.50 — —
148.50 —
a
c)
Switch 2
ON
OFF
ON
OFF
— —
a a
S102
OFF
OFF
ON
ON
23
Installation