Publicidad
Idiomas disponibles
Idiomas disponibles
2 Programming mode of the duration (in seconds) of the backwash (exhaust valve opening):
From "Working Mode" press for two consecutive times the button SET, the display shows the symbol " followed by a
number that indicate the duration of exhaust valve opening. Then press the MANUAL button to modify the number using
the SET button to decrease and the MANUAL button to increase the interval from a minimum of 2 seconds and a maximum
of 99 seconds. To confirm the currently selected interval do not touch any button for at least 3 seconds.
To come back into "Working Mode" do not touch any button for at least 10 seconds.
3 Manual opening of the exhaust valve
From "Working Mode", press the button MANUAL, the valve opens for the time set in step 2. When the valve is open on the
screen appears "FLH". After the valve closing the display shows "ATT" for 60 seconds, during this time the manual opening
can not be operated. At the end of the 60 seconds the device comes back on "Working Mode".
WARNINGS
The pin type adapter must be inserted in a standard socket, equipped with ground contact and protected by a circuit breaker.
Make sure the adapter is firmly inserted in the socket and located in a protected area, away from accidental contacts, water
sprays, humidity and heat sources.
WARNING: the programmer must be set with dry hands and appropriate tools.
HYDRAULIC CHECKS AND START-UP
Proceed as follows after filter drain installation and connection:
- Make sure there are no water leaks by gradually opening water supply to the filter;
- Make sure the system is correctly positioned to facilitate routine maintenance operations;
- Make sure sampling faucets are installed before and after the device;
- Make sure the drain pipe is firmly secured and that no water leaks during filter cleaning;
- Check whether any flood protection devices are needed, installed and efficient;
- Check whether an adequately dimensioned drain is installed and periodically check for clogs;
- Check system correspondence with any local standards or recommendations;
- Gradually fill the filter 3/4 full and release air in the filter.
PROBLEM
Water leaks between the cup and
solenoid valve
Water leaks at drain
After the connecting to power supply
the display does not turn on.
DECLARATION OF COMPLIANCE
Manufacturer's address: ATLAS FILTRI srl - Via del Santo 227, 35010 Limena (PD) - ITALY
HYDRA AUTO filters are constructed in accordance with the following European directives:
N° 2004/108/EC - Electromagnetic compatibility.
N° 2006/95/EC - Low voltage directive.
UNI EN 1717 - Protection against pollution of potable water in water installations and general requirements of devices to prevent pollution
by backflow.
Specifically, the following harmonised regulations were applied:
EN 50081-1, EN 55014, EN 60800-2, EN 61000-4-4, EN 61000-3-2, EN 61000-3-3, EN 55104, EN 60204-1.
CAUSE
- nipple o-ring worn.
- build-up in the solenoid valve body.
- the plug is not fully inserted;
- the programming panel is broken.
SOLUTIONS
- replace the o-ring.
- manual clean once or several times.
- check if correctly inserted;
- contact the dealer.
Publicidad
