Audizio RP310 Manual De Instrucciones página 4

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts
are present, and have been received in good condition. Notify the shipper immediately and retain packing material for
inspection if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and
all packing materials. In the event that the product must be returned to the factory, it is important that the product be
returned in the original factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
1. Platter
Place your record here.
2. Tonearm
3. 45 RPM adapter
This adaptor allows you to play 45RPM records.
4. Tonearm clip
This specially designed arm clip secures the tonearm while at rest or
when not in use. The arm clip has been designed to remain in the up
position while unlocked.
5. Cartridge with needle
When the turntable is not in use, it is recommendable to place the
removable protection cover over the stylus.
6. Power ON/OFF button
Push the Power On/Off button on the unit to turn on/off the turntable.
7. Speed button
This switch controls the RPM of the turntable platter.
8. Start/Stop button
Press the START/STOP button to start the turntable ; push it again to
stop it.
9. Return
Press to force the tonearm to return to the arm-rest position.
10. Lift
Press to lift the tonearm. Move the tonearm gently to the desired position above the vinyl record. Push the lift button
again to lower the tonearm slowly onto the record to begin playback.
11. Dust cover
12. USB port
Use the included USB cable to connect your turntable to your computer. The USB connection will send audio from the
turntable to your computer.
13. DC input
Connect the power adapter.
14. RCA line output
Line signal RCA connectors to connect the record player to a mixer or an amplifier.
1. Connect an external amplifier or speaker system via the RCA output connector. NOTE: the RCA cables are color coded. The
red plug cable must be plugged into the red connector on both the record player and external amplifier or speaker system.
The white plug cable must be plugged into the white connector on both the record player and external amplifier or speaker
system.
2. Insert the DC plug of the adapter firmly and securely in the DC IN connector on the back of the unit. Connect the other end
of the adapter cable to a power outlet.
3. Before use: remove the needle protection cover.
Although the best care has been put into the production of this record player and it's mechanical components, the situation
can occur that the drive belt could come loose (for example during transport). If so,
please follow the below steps to put the belt back onto the motor pulley.
A. Remove the rubber mat from the turntable platter and the E ring from the
turntable shaft. Release the turntable platter from the shaft.
B. Put the drive belt on the inner rim of the turntable platter and put the platter back
over the shaft.
C. Hold the belt with your fingers and place the belt onto the motor pulley as shown
in the drawing.
D. Clip the E ring back on the shaft and place the rubber mat onto the turntable platter.
Note: avoid oil on the belt as the oil will make the belt slippery. Please make sure that the belt is not distorted or twisted.
4