Publicidad
Idiomas disponibles
Idiomas disponibles
Net System Description
Bottom of table top
in vertical position
Net Post Stop
Nut Plate
Left Net Post
Assembly
1. Net Post Assembly
Attach plastic net post as shown with washer and knob. Note:
there is a left and right net post assembly (See Net System
Description). Post assembly should rest flat against nut plate.
Slide the net sleeve over the vertical post while the net post
assembly is folded in toward the side of the table top. Fold the
net post assembly out against the net post stop into the post
and secure bead chain in catch.
Nut
Washer
#31
Net Post Assembly
Knob #32
2. Adjustments
A - Adjust overall net tension by slightly lossening the knob and moving
net post assembly. Moderately tighten knob. Net post assembly should
be kept square with the table by the net post stop (See Net System
Description).
B - Adjust tension of cord with bead chain on each side. Assure that
chain is fully seated in catch.
C - Position top of net to a regulation height of 6" from the table surface
by firmly gripping the certical net post within height adjustment slot.
Right Net Post
Assembly
Sleeve
Cord
Bead
Tabs
Catch
10
C
B
Height
A
adjustment
slot
Publicidad
