AudioSonic TXCD-1536 Manual De Instrucciones página 10

Play List
note: Program the playlist in stop mode only. Program up to 20 tracks in your desired
order.
• Press MEM/CLK-ADJ (13), the display shows the following readouts:
MEM
001 (flashes)
001 (flashes) +
is displayed
P01
• Repeatedly press FOLDER/PRE
TUNE+/ (15) or
• Press MEM/CLK-ADJ (13) to save, The next location on the play list is displayed.
• Repeat these steps until your play list is programmed.
• Press MEM/CLK-ADJ (13) to finish programming.
• Press MEM/CLK-ADJ (13) again to delete your program. MEM turns off on the
display.
iD3 tags (MP3/WMa files only)
note: With activated ID3 tag function the ID3 information in the file is read and
displayed. If no ID3 tag information is included or the device does not support the
format, and then NO TAG Is displayed.
• Press and hold ID3 (42) on the remote control to activate the ID3 function, until
"FILE - is displayed.
• Press ID3 (42) on the remote control again to deactivate the 1D3 function.
iMPortant
Note: Although this CD player can read CD-R, CD-RW and MP3 discs - in addition to
normal CD's - the playability of CD-R, CD-RW and MP3 discs may be affected by the
type of software that was used to create the discs, as well as the quality and condition
of the blank media you are using. 100% playability cannot be guaranteed. This is not
an indication of a problem with the player.
10
Instruction Manual
Program play list activated.
Current track number in first album.
Album number (MP3/WMA CDs only).
Location on the play list.
(14) to select the desired album, then press
/TUNE- (21) to select the track.
usB anD sD/MMc functions
connect Media
• Ensure that the device is turned off.
• Connect your USB device to the USB port (23).
• Insert your SD/MMC memory card with the label to the front into the SD/MMC
card slot (22) until it locks into place.
Disconnect Media
• Ensure that the device is turned off.
• Disconnect your USB device from the USB port.
• Carefully press down the SD/MMC memory card to unlock; then remove from the
SD/MMC card slot.
iMPortant
The USB port of this product is fully compatible with the USB 1.1 and 2.0 standard.
lf MP3 players connected to this port are not written in compliance with the official
USB 1.1 or 2.0 standard it may occur that those MP3 players do not work on this
port. This is not a defective of this product. The MP3 player does not comply with the
official USB 1.1 or 2.0 standard.
Playback
• Repeatedly press FUNCTION (6), until
TOC READ (read contents) flashes on the display, then the total number of albums
and tracks is displayed.
or is displayed.