Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The surface is still very
wet after vacuuming
the fluid.
Fluid is coming out of
the vacuum cleaner.
11. Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact
with mains voltages. Do not short-circuit the product. The device is not certified
for use in the open air; only use it in dry conditions. Protect it from high humidity,
water and snow. Keep it away from high temperatures. Do not subject the de-
vice to sudden changes in temperature or heavy vibration as this might damage
electronic components. Examine the device for damage before using it. The unit
should not be used if it has received an impact or has been damaged in any other
way. Please observe national regulations and restrictions. Do not use the device
for purposes other than those described in the instructions. This product is not a
toy. Keep it out of the reach of children or mentally impaired persons. Any repair or
alteration to the device not carried out by the original supplier, will invalidate the
warranty or guarantee. The product may only be used by persons who have read
and understood these instructions. The device specifications may change without
any separate prior notice to this effect.
English
Solution
• Ensure that the fluid attachment is fixed to the
vacuum cleaner.
• Hold the vacuum cleaner at an angle of about 30°
facing downwards properly onto the surface to be
vacuumed. Never tilt the appliance to one side and
ensure that the fluid attachment is touching the
surface.
• The filter unit is wet. Ensure that the filter unit is
dry before inserting the filter into the dust collector.
• Check whether the filter and the filter unit are
properly installed.
• Never exceed the maximum level marking for
liquids in the dust collector.
23
Publicidad
