Ruby Fires 4114 Manual De Usuario E Instrucciones De Seguridad página 6

Filling the ceramic burner with Ruby Fires bio ethanol 98% LEF, use only LEF to fill the ceramic burner.
• It is of great importance that the liquid never flows outside the filling opening.
• Make sure to fill the ceramic burner carefully and slowly, so it cannot be overfilled.
• In case liquid is spilled, use a soft, absorbing cloth to clean.
• For an optimal fire the burner has to be filled not higher than 1 cm below the surface of the ceramic element.
When the ceramic burner is filled with LEF for the first time, the ceramic element on the inside will be saturated completely. The liquid
will always remain partly absorbed by the brick. Therefore it is necessary to use more bio ethanol the first time the burner is filled than
the following times.
Ceramic burner Mini (4114)
Ceramic burner Small (4120 + Silo)
Ceramic burner Big (5820)
Ceramic line Burner (8014)
How to fill the ceramic burner:
• Open the latch for one third, so the filling-opening is visible. With square burner: open fully.
• Place the enclosed funnel in the filling-opening.
• Carefully pour the Ruby Fires bio ethanol 98% in the funnel until the ceramic brick is saturated, but make sure that the liquid level
remains underneath the surface of the element: at least 1 cm!
LEF
• Warning: Make sure that the liquid does not flow outside the filling-opening. In case liquid has been spilled outside the filling-
opening, make sure this is dried up before lighting the fire. Risk of fire! There should never be fire outside the fire-opening. This is
dangerous and can also cause the insert to de-form and damage of the paint of the insert.
• Warning: Keep on filling the burner until the level remains visible in the filling-opening. The level must remain at least 1 cm
underneath the surface.
• When the ceramic burner is filled, remove the funnel. You can now fully open the latch. The burner-opening is visible and the
ceramic burner is ready for use.
Latch open
How to re-fill the ceramic burner:
• Close the latch when the ceramic burner is burnt empty.
• Check carefully that there is no longer any fire on the surface.
• Warning: Never fill a burning burner – Life threatening!
• Wait at least 30 minutes for the Bio Flame Burner to cool down.
• For further instructions see: 'How to fill the ceramic burner"
Lighting the ceramic burner:
• There is a latch for the fire-opening on the topside of the ceramic burner.
• When the ceramic burner is not lit, this latch is closed (to prevent the bio ethanol from evaporating).
• By opening the latch the fire-opening with the ceramic brick becomes visible.
• The ceramic burner can be lit using a long lighter or a long matchstick, but only when nothing is placed on the opening and the
Ruby Fires bio ethanol 98% is well filled as described in: 'How to fill the ceramic burner'
First filling
± 1 liter
± 1.5 liter
± 2 liter
± 2,5 liter
Latch closed
Refill
± 0.8 liter
± 1 liter
± 1,5 liter
± 2 liter