Reset To Factory Settings - EVERSPRING AC134 Guía De Usuario

Note: Avoid the vertical angle between 70° to 90° as this is reserved for learning IR
code.
3. For longer range beyond 5m and up to 8m, the target appliance should be located at a
narrower elevation angle between 30° to 40° of AC134.
4. Once a location has been identified, stick the provided
anti-slip rubber pad below the base plate for better surface
grip.
Trouble Shooting
Symptoms Possible Cause
Device does not work, No batteries attached or no
LED does not illuminate. power.
LED does illuminate, Binding with gateway did
appliance does not not complete successfully.
respond IR code learning did not
complete successfully.
The device is too far from
the gateway and cannot
communicate with it.
Manual Binding
1. Repeat steps 3 to 5 of the Binding with HomeSys section.
2. Press and hold the Link button for 3 seconds until the LED flashes moderately (on for
0.5 second; off for 0.5 second). This implies AC134 has now entered the binding mode
Recommendation
Check if batteries are attached
or replace with new ones.
Bind again using manual
binding (see next chapter)
Redo IR code learning again.
Place the device nearer to the
gateway.
and is waiting to receive binding signals from the gateway.
3. Within 5 seconds, the LED indicator will stop flashing and turn off, indicating the
learning procedure is completed. The screen below will appear indicating the process
is successful.
after 30 seconds the LED flashes rapidly for 3 times, it means the AC134 failed the
binding process.

Reset to Factory Settings

To reset AC134 back to factory default state:
1. Press and hold the link button for 3 seconds until the LED flashes moderately then
release the button.
2. Within 30 seconds, press and hold the link button again, this time for more than 6
seconds until the LED turns off then release the button.
3. Unplug the DC adapter and remove the batteries.
4. Re-insert the batteries, if the LED blinks repeatedly once every 30 seconds this implies
the device is reset back to factory mode.
Specifications
Operating temperature range
Operating humidity
Adapter
Battery type
IR transmission range
IR compatible bitrates
RF Frequency
RF transmission range
*Specifications are subject to change without notice.
WARNING:
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities. Contact your local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak
into the groundwater and get into the food chain, damaging your health and well-being.
0°C to 40°C
85% RH at 30°C
DC 5V 1A
AA alkaline 1.5V *3
Up to 8m
32.0 - 50.0 KHz
868.30 MHz/923.00MHz
Outdoors >150m (Open space)
4. If