How To Use Advanced Functions; Turbo Function - EAS ELECTRIC ERCLMAJ Manual De Instrucciones

How to Use Advanced Functions

Swing function
Press Swing button
® ..
The horizontal louver will swing up and down
automatically when pressing Swing button.
Press again to make it stop.
SHORTCUT function (some units)
Press SHORTCUT button

TURBO Function

Press TURBO button
Clean Function
Press CLEAN button
Push this button when remate controller is on, the system will automatically
revert back to the previous settings including operating mode, setting
temperature, fan speed level and sleep feature (if activated).
lf pushing more than 2 seconds, the system will automatically restare the
current operation settings including operating mode, setting temperature, fan
speed level and sleep feature (if activated ).
When you select Turbo feature in COOL mode, the unit will blow cool air
with strongest wind setting to jump-start the cooling process.
When you select Turbo feature in HEAT mode, far units with Electric heat
elements, the Electric HEATER will actívate and jump-start the heating
process.
Airborne bacteria can grow in the moisture that condenses around heat
exchanger in the unit. With regular use, most of this moisture is evaporated from
the unit.
By pressing the CLEAN button, your unit will clean itself automatically. After
cleaning, the unit will tum off automatically. Pressing the CLEAN button mid-
cycle will cancel the operation and turn off the unit. You can use CLEAN as
often as you like.
Note: You can only actívate this function in COOL or DRY mode.
Keep pressing this button more than 2 seconds,
the vertical louver swing function is activated.
(Model dependent)
09
V.1