Troubleshooting - Medion MD 40820 Manual Do Utilizador

Troubleshooting

Question
When using the camera
The camera has no power.
Cannot power on my
camera even though
batteries is installed.
Cannot take pictures and
movies when pressing the
Shutter button
I did not delete the picture
and movie, but cannot find
the data in the SD/MMC
card.
Cannot set the strobe to the
"On" mode.
Answer
.
Check if your files are stored in the
camera's built-in memory. If there is a
icon at the right bottom section on the
LCD display, it means you are using the
camera with a SD/MMC card. Please
remove the card to find the data in the
flash memory. (For details, see the
"Removing the card" section on page 6)
Charging the flash strobe requires more
power of batteries. When the battery is
under the status of low power, the strobe
On
batteries.
~ 30 ~
The batteries may be out of power,
please change the batteries.
Make sure that the battery is installed
correctly.
Make sure that the battery is installed
correctly.
If it is idle over 3 minutes, the camera
will shut down automatically, please
press the Power button
Lens cover to power on the camera.
Make sure that the Lens cover
The storage is full. Please free some
space of the SD/MMC card or flash
memory.
Check if the camera is under the status
of charging batteries.
Check if the SD/MMC card is set to
"protected".
If the " MEMORY ERROR
shows on the LCD display, please set
the Mode switch to
the card.
cannot be set. Please change the
or slide the
is open.
" message
mode format