Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Determine the preferred height of the window mount base
against the back support.
5.
Align the bottom hole in the window mount base with the
preferred hole in the back support.
6.
Insert a 10-32 x 1/2" screw through the aligned holes in the
back support and base plate. Tighten.
7.
Before proceeding to the next section, remove the four
rubber feet and foot screws from the bottom of the
Pathway X1 or Carryout G2 antenna. Set aside until step 6
of the next section.
Installing the Antenna on the Mount
Failure to install in accordance with product manufacturer's installation and assembly instructions could result in
property damage, personal injury, and/or death.
1.
Decide where cables should exit in relation to the mount,
and choose one of two configurations for antenna
orientation below, considering the position of the cable
ports. Do not secure the antenna to the mount assembly
at this time.
Configuration #1
Configuration #2
Page 3
2.
After orienting the antenna according to one of the
configurations, remove the dome screw closest to the
back support with a 5/16" drive.
3.
Align the hole in the dome (where the dome screw was
removed) with the aligned holes in the window mount
base and back support.
4.
Install the dome screw through the aligned holes in the
back support and window mount base.
5.
Install the rubber washer on the dome screw, and install
the dome screw through the dome. Tighten.
Setting up the Window Mount
Publicidad
Tabla de contenido
