Installation Instructions - Vestil MT Manual Del Propietário

INSTALLATION INSTRUCTIONS

INSTALLING CASTERS (fig. 1)
1.) Two 5" dai. swivel casters are installed on one end of
base frame (handle end of platform) and 5" dia. rigid
casters are installed on other end.
2.) Place the caster base plate into the caster pad bracket
(located on the bottom of frame).
3.) Insert 3/8" x 16 UNC x 5" long carriage bolt through
the square hole in the caster pad to hold the caster in
place.
4.) Place 3/8"-16 UNC lock nut on each bold and tighten
securely.
BOLT
CASTER
INSTALLING FLOOR LOCK - (fig. 2)
1.) Align mounting plate of floor lock with predrilled holes
on bottom of frame.
2.) Install floor lock with foot pedal bracket facing out.
3.) Insert four 3/8"-16 x 1" long hex head cap screws
through top of frame.
4.) Place four 3/8" - 16 lock nuts on each bolt and tighten
securely.
2
NUT
CASTER PAD
BRACKET
Figure 1
Figure 2
OPERATING INSTRUCTIONS
MANUAL HAND CRANK
Attach hand crank. Turn clockwise to raise unit and counter
clockwise to lower unit.
DC POWERED
Position of the deck is controlled by the hand-held pendent
control. The arrows display direction of travel of deck.
In order to operate the unit, pressure must be maintained in
the UP or DOWN position to raise or lower deck. On releasing
either button, the deck will remain at that particular position
until the button is depressed again.
RESPONSIBILITIES OF OWNERS/USERS
It is the responsibility of the owner/user for the following:
1.) The lift must be inspected and maintained in accordance
with the guidelines in this manual.
2.) Any lift not in safe operating condition must be removed
from service until it is returned to proper operating condition.
Unsafe condition may include, but is not limited to the following:
missing rollers, pins, or fasteners, any cracked or deformed
structural members, cut or frayed electric lines, and damaged
controls or safety devices.
All repairs and maintenance must be performed by qualified
personnel.
3.) Lift may only be used be used by authorized personnel.
All lift operators must have read and understood all
operating procedures and safety guidelines in this Owner's
Manual.
4.) Lift must never be overloaded.
5.) Operator must ensure that all safety features of the lift are
functioning properly before each use.
6.) Any modifications to the lift must be approved in writing by
the manufacturer.